AutoCAD Inventor :: Align View Options In IDW

I am detailing a drawing with typical hole dimensions on a piece of steel angle. The drawing is setup such that the fabricator will have two options for each end of the steel angle. I have created two parts with the two options per end and have placed them outside of the page for reference.

I would like to reference each end of each piece, so that there are four pairs of views on the page (the two legs of the angle at each of the four ends), aligned in a grid. I have determined the best way to do this is with detail views. (Using breaks causes the break sign to appear huge, given the large gap I want between views. Using cropped views does not make it obvious that each end is a cutaway.)

My issue now is aligning the eight views. I know of the align options (horizontal, vertical, and in position), but they align to the "origin" of each detail, which is the center. With the angles being the same size, this works fine horizontally, but vertically, the pieces will never line up exactly, which is crucial to at least lining up the two legs of a single angle. The best I seem to be able to do is get the detail sizes as close to exact as possible so the centers come close to lining up. Even creating a projected view from a detail treats the cutaway end as part of the geometry, making it look a bit ridiculous.

way to precisely line up the views? I have done extensive searching and am confident that there is no inherent way to align based on a point or edge (seems like a deficiency on Autodesk's part), but is there a way to move the origin of a detail or something like that?