AutoCAD Inventor :: Make A View Showing Motor Jack Screw Unit

I'm trying to make a view showing a motor-jackscrew unit with the jackscrew at the fully retracted position and also with the jackscrew at the fully extended position (in phantom).  Refer to the attachment.

My initial plan was to have two views in the drawing, one retracted and one extended, and then just align them vertically and horizontally.   But it turns out that you can only align vertically OR horizontally, not both at the same time.  So I created an assembly of two iAssemblies, one with the screw extended and one retracted.  Then I made the drawing view from the direction that placed the extended assembly directly behind the retracted assembly.