AutoCAD 2010 :: Plotting Lines Using Compass Direction For Lines Angle

i am doing a simple project making a survey plot for a piece of land that will be broken into subdivision. all measurements are of my starting point. after plotting the starting point i try to draw line that is 113 feet long and at a bearing of N 5d W i have no problem entering this data but when i hit enter it draws a straight line. now i know 5 degrees is much of an angle so i thought maybe it just looked straight and tried to plot the next point which was 542 feet from the last point at a bearing of N 39d E but once again after i put the info in and hit enter or space it would plot a line of the proper length but vertical, not the proper angle i need it at. here is how i would put in the info:

first i choose the lne command and choose my "beginning point" as that starting point for my line then i type 113<N 5d W for the length and direction and hit enter. when i do this it plots a vertical line of the proper length but wrong angle. what am i doing wrong? i have ortho set to off and idk what else to mess with